HK SP 42C
Coil for solenoid-operated directional control valve HK42CProduct image
Properties
Scope of supply |
with O-ring |
Corresponding connectors |
HKSP664, HKSP666, HKSP667, HKSP668 |
Note
As far as AC coils are concerned, power input is considerably higher in the take-up phase than in the stopping phase.
These must therefore never be operated without a magnet core since there is a danger of overheating and the coil can burn through.
A similar effect occurs if valves with AC magnets are operated with extremely high pulse frequencies (On / Off). In such cases the coils, which are often in the vicinity of the high power input, can also overheat. For such applications the use of RC coils with rectifier plugs is recommended.
With DC coils extremely high power spikes can occur during powering down. We therefore recommend the use of plugs with protective circuits when using such coils.
Item
Sort upwards
Sort downwards
Identification | Nominal voltage +/- 10 % | Average power consumption (W) |
Average current consumption (A) |
Weight (kg) |
---|---|---|---|---|
HK SP 12V 42C | 12 VDC | 37 | 3,13 | 1,10 |
HK SP 24V 42C | 24 VDC | 36 | 1,50 | 1,10 |
HK SP 205V 42C | 205 VDC | 36 | 0,18 | 1,10 |
HK SP 115V 42C | 115 VAC | 41 | 0,99 | 0,52 |
HK SP 230V 42C | 230 VAC | 41 | 0,50 | 0,52 |
Ordering information
Other types of coil on request
Accessories
- HK SP DIN 43650
- Electrical plug for solenoid coil DIN 43650 / ISO 4400
- HK UEB MUT
- Cap nut for solenoid-operated directional control valve
Spare part for following products
- HK 42 C1 (7/G/Q/R)
- Solenoid-operated directional control valve NG10
Disclaimer
Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.