K-MV G 230 V, 50 - 60 HZ IV
Normally closed, 230 V / 50 to 60 Hz, internal pilot controlProduct image
Properties
Electrical connection |
ISO 4400 (Pg 11P connector socket) |
Protection IP |
IP65 (with connector socket fitted) |
Media temperature |
max. +90 °C |
Operating pressure |
min. 0,35 bar; max. 8,5 bar |
Relief port (type 2) |
G 3/8 (K-07302231 und K-07302304), G 3/4 (K-07302232 und K-07302305, K-07302233 und K-07302306), Silencers can be retrofitte |
Housing |
Aluminium |
Internal parts |
Stainless steel |
Diaphragm |
Type 1 TPE (Hydrel); Type 2 CR (chlorophene/neoprene) |
Seal |
Perbunan (NBR) |
Description
Environmental protection today demands state-of-the-art cleaning processes. Dust filter systems are an indispensable aid to pollution control. The fabric filters installed in these systems are cleaned by blowing in compressed air pulses in quick succession counter to the main direction of flow. The solenoid valves used for this purpose are characterised by the following application-specific design features:
- Angle type of construction to optimise the air flow
- Full cross-section at the valve seat
- Extremely fast opening and closing
- Quiet operation thanks to built-in silencers (can be retrofitted in sizes 1 1/2 to 2 1/2)
- Easy maintenance and repair because diaphragm and wearing parts are instantly available
The valves are not suitable as shut-off devices for standard applications.
Note
Further information on request
Item
Disclaimer
Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.