Select language
Bulgarian (Български)
Chinese (汉语)
Croatian (Hrvatski)
Czech (Čeština)
Dutch (Nederlands)
Estonian (Eesti)
French (Français)
German (Deutsch)
Hungarian (Magyar)
Italian (Italiano)
Latvian (Latviešu)
Lithuanian (Lietuvių k.)
Polish (Polski)
Portuguese (Português)
Romanian (Română)
Russian (Русский)
Serbian (Српска)
Slovakian (Slovenčina)
Slovenian (Slovenščina)
Spanish (Español)
Turkish (Türkçe)
K-BEFUELLVENTIL HANSA
Filling valves (start-up valves)
Product image
Properties
| Input pressure |
2.5 - 16 bar |
| Temp. range |
-10 °C to +50 °C |
| Media |
Compressed air |
| Connection thread |
Material: Die-cast zinc |
| Housing |
Material: Grivory® (PA 66) |
| Flow rate measurement |
At P2 = 6 bar, pressure drop Δp = 1 bar |
Description
Seat valves operated by secondary pressure for controlled pressurisation of pneumatic systems. These valves prevent a sudden build-up of pressure accompanied by dangerous, jerky cylinder movements. The full cross-section of the regulator is opened at 50% of the input pressure. The filling time can be altered by turning the adjusting screw.
Note
Further information on request
Item
Sort upwards
Sort downwards
 Identification |
Thread | Flow rate (L/min) |
A (mm) |
B | C (mm) |
D (mm) |
|---|---|---|---|---|---|---|
| K- 07 25 11 11 | G 1/4 | 1300 | 52,0 | 78.0 mm | 45,0 | 33,0 |
| K- 07 25 11 12 | G 3/8 | 1300 | 52,0 | 78.0 mm | 45,0 | 33,0 |
| K- 07 25 11 13 | G 3/8 | 3400 | 63,0 | 111.5 mm | 53,5 | 58,0 |
| K- 07 25 11 14 | G 1/2 | 3400 | 63,0 | 111.5 mm | 53,5 | 58,0 |
| K- 07 25 11 15 | G 3/4 | 8750 | 85,0 | 112.0 mm | 58,0 | 54,0 |
| K- 07 25 11 16 | G 1 | 8750 | 85,0 | 112.0 mm | 58,0 | 54,0 |
Additional information
See 3/2-way valves and filling units
See 3/2-way valves and filling units
Spare parts
- K-HALTERBAUSATZ HANSA
- Holder HANSA
Disclaimer
Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.