HANSA-FLEX AG
You are using Internet Explorer.
Deactivate the compatability mode if necessary, to experience the catalog the best way.

search Find

Search help

English

Select language

Date: 2017-10-19

K-DRG DRV 200 STANDARD

DRV 200 pressure regulators, standard type
Hide product imageProduct image
K-DRG DRV 200 STANDARD data/img/product/00042367_0.jpg - K-DRG DRV 200 STANDARD
Hide propertiesProperties
Input pressure Max. 25 bar (Series 200 and 300 Series), Max. 40 bar (400 Series)
Temp. range Max. 75 °C
Reduction ratio Max. 10:1 (200 Series), Max. 20:1 (300 Series), Max. 6:1 (400 Series)
Sealant NBR
Spring bonnet Pressed brass up to DN 25, Grey cast iron from DN 32
Housing Red brass 2.1096.01
Hide descriptionDescription

Diaphragm pressure regulators with non-self-relieving design and non-pressure-reduced single-seated valve. Very precise adjustment. Good response characteristic because of only a few moving parts which hence minimal friction. Ideal for compressed air, nitrogen and other neutral, non-flammable gases, but only suitable for liquids with comparatively low flow rates.

Hide informationNote

Further information on request

Hide product tableItem

Sort upwards

Sort downwards

Hide additional informationAdditional information

Other designs available on request

Hide ordering informationOrdering information

Other designs available on request

Hide product spare partsSpare parts
K-VERSCHLEI-SATZ
Set of wearing parts
Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.