K-LKM S NW7,6 AG
Safety couplings DN 7.6, maleProduct image
Properties
Operating pressure |
Max. 16 bar |
Flow rate air |
2.250 l/min (at 6 bar and Δp = 0.5 bar) |
Media temperature |
-20 °C to +100 °C |
Material |
Galvanised steel / brass |
Spring |
Stainless-steel |
Sealant |
NBR |
Description
High-quality, robust and durable, one-hand quick disconnect safety couplings, with very high flow rates and only a small pressure drop.The coupling is released fully automatically in two steps. Air is relieved from the coupling before it is completely disconnected, to minimise the risk of injury to the operator from hose ends flying around. The plug is only disconnected from the coupling if the residual pressure has dropped below 0.3 bar. The dreaded "whiplash effect" is thus avoided and the risk of injury virtually eliminated. This safety version conforms to ISO-Standard DIN EN ISO 4414.
Note
Further information on request
Item
Sort upwards
Sort downwards
Identification | Connection | Length (mm) |
AF (mm) |
---|---|---|---|
K- 07 35 13 19 | R 1/4 male | 63,0 | 20 |
K- 07 35 13 21 | R 3/8 male | 61,0 | 20 |
K- 07 35 13 16 | R 1/2 male | 55,5 | 22 |
Additional elements
- K-NIPPEL KUPPL NW7 AG VZ PTFE
- Plugs for couplings DN 7.2 - DN 7.8, hardened and galvanised steel, male threaded, FPM (PTFE coated) seal
- K-NIPPEL KUPPL NW7 IG VZ 1
- Plugs for couplings DN 7.2 - DN 7.8, hardened and galvanised steel, female
- K-NIPPEL KUPPL STREAM LINE
- Plugs for couplings DN 7.2 - DN 7.8, hardened and galvanised steel »stream line«
- K-TUE 7,2 7,8 ST VZ 2
- Stems for couplings DN 7.2 - DN 7.8, hardened and galvanised steel
Disclaimer
Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.